Seems like you just about can't go wrong with any of the C2Ds. Let's compare some of the performance to default speed next ->Įnjoyed the review. However, I will leave this to those who need more speed than I to adventure for more fun Why not leaving some of the fun for others to enjoy. I know this E4500 sample might likely go higher with more juice to it. I stated at the beginning that I wouldn't go over 1.4vcore. In fact, the fan noise from the graphic card was much louder when I was running 3DMarks. 1.4 volt I yelled BIOS returned 1.375.Īt load, vdroop slided down to 1.35 volt and CPU fan speed never went over 2,500 rpm. With a little grin in my face, I popped the CPU and re-opened the spreadsheet. When I tried for 292FSB or 3.2GHz OCCT failed at the last few minutes of the test. I ran SuperPi 1M just to make sure it works.ĬPU temp remained at a comfortable zone of below 50☌. Keeping the memory at 4:5 ratio and way below 400MHz at loose timing, I want to make sure the memory is not causing problem. Delighted, I set the FSB to 266, making it closer to E6800 territory for a fraction of the cost should it work. I entered 1.385v to be my desired voltage pin-modded accordingly, and was greeted by 1.352 volt at BIOS.
0 kommentar(er)
